Time Server Configuration; Secure Login Configuration - GE Healthcare Optima XR200amx Installation Manual

GE H
EALTHCARE
D 5336113-1EN, R
IRECTION
Table 4-10 PNF parameters
Add New Filter
NAT tab
Used to define NAT (Network Address Translation) rules.
Name/Source IP/Dest. IP
Remove Existing Filters
Add New Filter
GE Service tab
Used to set IIP node-lock IP address and DICOM port. This page is limited to GE service
personnel.

4.2.10 Time Server configuration

Contact a GE service representative to configure Time Server settings.

4.2.11 Secure Login configuration

Select SAVE to apply your changes, or CANCEL to cancel them.
Use the arrow buttons to move through the pages.
Table 4-11 Secure Login options
Audit Message Settings tab
Audit Source ID
Patient Name
Anonymized
Enterprise Repository tab
Enterprise Repository 1
Host Name/IP
Page 66
10
EVISION
Option
In the Name field, specify the filter name.
In the Allowed IPs field, specify a particular IP address, a range
of IP addresses, or a masked subnet.
In the Allowed Port field, specify a particular port.
From the Protocol drop-down list, select the protocol to be
allowed (TCP, UDP, Any).
Select ADD FILTER to apply your changes.
Lists current filters by name, source IP, destination IP,
destination port, and protocol.
Select the Delete box checkbox next to the filter to delete, then
select DELETE EXISTING FILTERS.
In the Name field, specify the filter name.
In the Source IP field, specify the source IP.
In the Destination IP field, specify the destination IP.
In the Destination Port field, specify the destination port.
From the Protocol drop-down list, select the protocol to be
allowed (TCP, UDP, Any).
Select ADD FILTER to apply your changes.
Option
IP address of audit message source.
On or Off.
On or Off.
Primary audit server name or IP.
Section 4.2 Using the System Configuration Tool (SUIF)
O XR200
PTIMA
I
NSTALLATION
Description
Description
/XR220
AMX AMX
M
ANUAL