Connecting The Barcode Reader; Barcode Reader Led Indicators; Charging The Barcode Reader - GE Healthcare Optima XR200amx Installation Manual

GE H
EALTHCARE
D 5336113-1EN, R
IRECTION

4.10.1.2 Connecting the barcode reader

1.
2.
3.
4.
5.

4.10.1.3 Barcode reader LED indicators

By default, the OPI-4002 scanner is in power saving mode. To turn it on, press the trigger key for a
few seconds. If the scanner is not in use for a while, it will go into sleep mode and the trigger key
must be pressed for a few seconds to reactivate the unit before scanning.
The table below lists the state of the scanner based on the scanner LEDs.
Table 4-15 LED indicator state
Green
Red Blinking
Red Solid

4.10.1.4 Charging the barcode reader

The barcode reader will not start up if the battery is empty. Use the charging cradle to charge the
battery. It takes about three hours to fully charge a battery. Adapters are provided to connect the
AC/DC converter to various power outlet configurations.
10
EVISION
Item Description
1 Host PC
2 Detector power supply (Optima XR220amx and Optima XR200amx with digital
upgrade only)
Figure 4-4 Connect USB cable to PC
The Windows standard device driver will be installed automatically when you connect the
barcode reader receiver to the USB port and the system is powered up.
During initialization, the LED is orange. When the receiver LED turns green, the initialization
is complete and a connection has been made.
Turn on system power.
Verify that the USB receiver is connected and that the green LED is blinking.
On the barcode reader, press the trigger key to start scanning.
Scan the barcode label on the USB receiver
The connection is complete and the barcode reader is ready for use.
Do not replace the covers at this point. You will need to scan the barcode receiver label
during configuration.
Each time the system is rebooted, a message saying, "Do you want to connect to a
bluetooth SPP?" appears. The user needs to select YES or the barcode reader functionality
will not be enabled.
Color
Barcode was successfully read.
Data transmission error. The battery may need to be charged.
Charging on the cradle. The LED changes from red to green when the battery
is fully charged.
Chapter 4 Configuration
O
PTIMA
(Figure 4-1) to register the barcode reader.
Description
XR200 /XR220
AMX AMX
I M
NSTALLATION ANUAL
Page 77