Section 4.12 Enabling Advanced Service Mode; Section 4.13 Ip Address Change Procedure - GE Healthcare Optima XR200amx Installation Manual

GE H
EALTHCARE
D 5336113-1EN, R
IRECTION
4.
5.
6.
7.
8.
9.
10. Remove the Definium AMX 700 backup media from the CD/DVD drive and disconnect the
11. Type exit to close the terminal window.
12. Exit the Engineering User Interface.
13. Reset the system.

Section 4.12 Enabling Advanced Service mode

Advanced Service (sometimes called "in-house service" or "extended service") is available to
customers that have purchased an Advanced Service package license from GE Healthcare.
Contact a GE service representative to enable Advanced Service.
Advanced Service provides the following functionality:
•
•
•
•
The following functionality is never included in an Advanced Service license:
•
•
•

Section 4.13 IP Address Change Procedure

The system uses IP Addresses 192.168.x.x for communication between the PC and the detectors.
If the hospital network to the PC is also 192.168.x.x, issues will occur. Perform the following
Page 100
10
EVISION
Press CTRL + SHIFT + F5 to open the Engineering User Interface.
On the Engineering User Interface, press the TERMINAL icon.
At the command prompt, type:
mount /media/cdrecorder
Press ENTER.
cd /magichome/xruser/config/restore/
Press ENTER.
At the prompt, type:
chmod 777 restoreCustomIPLooks_F2toF3.sh
Press ENTER.
At the prompt, type:
./restoreCustomIPLooks_F2toF3.sh
Press ENTER. The script takes approximately 20 minutes to run. When completed, the system
returns to the prompt.
At the prompt, type:
umount /media/cdrecorder
Press ENTER.
drive from the system.
SUIF in Advanced Service mode
Detailed error descriptions in the Service Error Log Viewer
Advanced diagnostics
Extended error log with filtering
InSite ExC configuration
Advanced service configuration or entitlement
Purchased options configuration
Section 4.12 Enabling Advanced Service mode
O XR200 /XR220
PTIMA AMX
I M
NSTALLATION ANUAL
AMX