Show Sysinfo; System Utility Commands; Traceroute; Section 18.2 "System Utility Commands - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

18.1.11 show sysinfo

This command displays switch information.
Format
Mode
Switch
Description
System Name
System Location
System Contact
System ObjectID
System Up Time
MIBs Supported

18.2 System Utility Commands

This section describes the commands you use to help troubleshoot connectivity issues and
to restore various configurations to their factory defaults.

18.2.1 traceroute

Use the
traceroute
traveling to their destination through the network on a hop-by-hop basis. The
value should be a valid IP address. The [port] value should be a valid decimal integer in
the range of 0(zero) to 65535. The default value is 33434.
The optional port parameter is the UDP port used as the destination of packets sent as part
of the traceroute. This port should be an unused port on the destination system.
Format
Mode
System Maintenance Commands
show sysinfo
Privileged EXEC
Text used to identify this switch.
Name used to identify the switch.The factory default is blank.
To configure the system name, see
server" on page
Text used to identify the location of the switch. The factory
default is blank. To configure the system location, see
10.1.1 "snmp-server" on page
Text used to identify a contact person for this switch. The fac-
tory default is blank. To configure the system location, see
Section 10.1.1 "snmp-server" on page
The base object ID for the switch's enterprise MIB.
The time in days, hours and minutes since the last switch
reboot.
A list of MIBs supported by this agent.
command to discover the routes that packets actually take when
traceroute <ipaddr> [port]
Privileged EXEC
v1.0, March 2006
Section 10.1.1 "snmp-
10-1.
10-1.
Section
10-1.
<ipaddr>
18-17