This chapter introduces the Command Line Interface Reference for the ProSafe 7300S
Series Layer-3 Stackable Switches, Software Version 4.0. It describes the command-line
interface (CLI) commands used to view and configure the 7300S Series Stackable Switch
software. You can access the CLI by using a direct connection to the serial port or by using
telnet or SSH over a remote network connection.
1.1 Audience
This document is for system administrators who configure and operate systems using
7300S Series Stackable Switch software. Software engineers who integrate 7300S Series
Stackable Switch software into their hardware platform can also benefit from a description
of the configuration options.
This document assumes that the reader has an understanding of the 7300S Series
Stackable Switch software base and has read the appropriate specification for the relevant
networking device platform. It also assumes that the reader has a basic knowledge of
Ethernet and networking concepts.
1.2 Scope
This manual is written for the 7300S Series Stackable Switch according to these
specifications:
Table 1-1. Manual Specifications
Product
Product Final Assembly Number
Firmware Version Number
Manual Part Number
Manual Publication Date
About This Manual
ProSafe 7300S Series Layer-3 Managed Stackable Switch
Beta Draft 1
March 2006
Publication Version 1.0, March 2006
Chapter 1
About This Manual
1-1