Dhcp Commands - NETGEAR ProSafe FSM7326P Cli Reference Manual
Layer-3 stackable switches, software version 4.0
Hide thumbs
Also See for ProSafe FSM7326P:
- Hardware installation manual (38 pages) ,
- Installation manual (2 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
This section describes the DHCP commands available in the 7300S Series Stackable
Switch CLI. DHCP automatically allocates and manages client TCP/ IP configurations.
DHCP uses UDP as its transport protocol and supports a number of features that facilitate
in administration address allocations.
The DHCP Server Commands section includes the following topics:
•
Section 7.1 "DHCP Server Commands (DHCP Config Pool Mode)" on page 7-2
•
Section 7.2 "DHCP Server Commands (Global Config Mode)" on page 7-9
•
Section 7.3 "DHCP Server Clear and Show Commands" on page 7-11
•
Section 7.4 "DHCP and BOOTP Relay Commands" on page 7-15
The commands in this section are in one of three functional groups:
•
Configuration Commands are used to configure features and options of the switch. For
every configuration command there is a show command that will display the
configuration setting.
•
Show commands are used to display switch settings, statistics and other information.
•
Clear commands clear some or all of the settings to factory defaults.
DHCP Commands
v1.0, March 2006
Chapter 7
DHCP Commands
7-1
Advertisement
Chapters
Table of Contents
