Storm-Control Flowcontrol - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
9.2.1.1 no storm-control broadcast
This command disables broadcast storm recovery mode.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any
Ethernet port exceeds the high threshold percentage (as represented in
link speed, the switch discards the broadcasts traffic until the broadcast traffic returns to
the low threshold percentage or less. The full implementation is depicted in the
Format
Mode

9.2.2 storm-control flowcontrol

This command enables 802.3x flow control for the switch and only applies to full-duplex
mode ports.
Note: 802.3x flow control works by pausing a port when the port becomes
Default
Format
Mode
9.2.2.1 no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
Format
Mode
9-6
no storm-control broadcast
Global Config
oversubscribed and dropping all traffic for small bursts of time during the
congestion condition. This can lead to high-priority and/or network control
traffic loss.
disabled
storm-control flowcontrol
Global Config
no storm-control flowcontrol
Global Config
v1.0, March 2006
Table
Port-Based Traffic Control Commands
9-1) of the
Table 9-1.