Ignition Coil; Chassis Ground Point - Polaris RZR 900 2017 Service Manual

IGNITION COIL

OPERATION OVERVIEW
q
The ignition coil is used to provide high voltage to fire
the spark plugs. When the ignition key is on, DC voltage
is present in the primary side of the ignition coil windings.
During engine rotation, an AC pulse is created within the
crankshaft position sensor for each passing tooth on the
flywheel's encoder ring. The encoder ring missing tooth
creates an "interrupt" input signal, corresponding to
specific crankshaft position. This signal serves as a
reference for the control of ignition timing. The ECU then
calculates the time interval between the consecutive
pulses, and determines when to trigger the voltage spike
that induces the voltage from the primary to the
secondary coil windings to fire the spark plugs.
COIL TESTING
PRIMARY COIL TESTING
TEST
q w
to
e w
to
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
© Copyright Polaris Industries Inc.
TEST
PTO wire
MAG wire
IGNITION COIL / PLUG WIRE
REPLACEMENT
The engine will misfire if the spark plug wires are
should be installed to the corresponding cylinder
1. Remove the seats and engine service panel to
2. Disconnect the ignition coil harness and remove the
3. Remove the fastener retaining the ignition coil and
4. Install the new ignition coil and/or high tension lead

CHASSIS GROUND POINT

The chassis ground point
driver's side rear tire, near the voltage regulator
Ω RESISTANCE
0.4 Ω
PLUG WIRE TESTING
r t
to
y u
to
NOTICE
installed incorrectly. The spark plug wires are
marked with PTO and MAG from the factory and
and ignition coil post.
access the ignition coil.
high tension leads from the coil.
remove it from the vehicle. If replacing the high
tension lead(s), remove the other end of the lead(s)
from the spark plug.
(s).
TORQUE
Ignition Coil Retaining Bolt:
75 in-lb (9 Nm)
q
is located in front of the
ELECTRICAL
Ω RESISTANCE
1296 Ω
1728 Ω
w
.
12
12.39