Polaris RZR 900 2017 Service Manual page 151

4. Clean the o-ring sealing surface
block using a clean shop towel.
5. Use a shop light to illuminate the water pump drive
access hole in the engine crankcase. Note the
orientation of the water pump drive slot
6. Rotate the water pump drive tab
angle of the drive slot in the engine.
7. Slide water pump into engine crankcase.
CAUTION
The water pump drive tab and slot must be aligned
properly or severe engine damage will occur.
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
© Copyright Polaris Industries Inc.
w
in the engine 8. Install the three water pump mounting bolts
noting location of the shorter bolt. Torque bolts to
specification.
e
.
r
so it matches the
9. Install the three coolant hoses that attach to the water
pump. Be sure orientation and routing are correct.
10. Connect the (-) negative battery cable.
11. Fill and bleed the cooling system. (see Cooling
System Bleeding page 3.12)
ENGINE / COOLING SYSTEM
TORQUE
Water Pump Mounting Bolts:
7 ft-lb (10 Nm) (Apply Loctite® 204™ to bolt
threads)
ty
,
3
3.17