Polaris RZR 900 2017 Service Manual page 156

ENGINE / COOLING SYSTEM
INSTALLATION
w
1. Install new seal into crankcase. Thread the drive
bolt of special tool PU-52493
IMPORTANT
The orientation of the seal is critical. Install the seal with
the flat side of the seal facing out as shown.
3.22
q
into the crankshaft.
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
2. Tighten the drive bolt
out against the crankcase.
3. Once the seal is properly installed, loosen the drive
e
bolt and remove special tool PU-52493 from the
crankshaft.
4. Refer to PVT Inner Cover Assembly page
5. Test drive the vehicle and recheck for leaks before
putting back into service.
e r
until the cylinder bottoms
.
© Copyright Polaris Industries Inc.