Starter Solenoid - Polaris RZR 900 2017 Service Manual

Hide thumbs Also See for RZR 900 2017:

Table of Contents

7. Install (-) negative battery cable to the upper starter

mounting bolt / stud. Torque nut to specification.

Starter Mounting Bolts and Nut:

7 ft-lb (10 Nm)

STARTER SOLENOID

Starter Solenoid Bench Test

Test the start solenoid by powering the solenoid using

battery voltage for a maximum of 5 seconds. With the

solenoid energized, resistance should read about 0 - 0.5

ohms between terminals (A) and (B). If resistance

measurement is out of specification, replace the starter

Starter Solenoid Operation

To energize the Starter Solenoid the following must

• The brake must be applied to provide a ground path

via the orange wire.

• The key switch must be turned to the "start" position to

provide 12V power via the Green / White wire.

• Once the pull-in coil is energized, the solenoid

provides a current path for 12V power to reach the

starter motor.

See "ELECTRICAL SYSTEM BREAKOUTS: Starter-

Interlock" provided in this chapter for starter

solenoid operation.

Starter Solenoid Cable Fasteners:

35 in-lb (4 Nm)

9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual

Table of Contents