Polaris RZR 900 2017 Service Manual page 401

11. Look down into the transmission housing to see the
snorkel locking screw hole opening
your starting point.
NOTICE
If you have a hard time seeing into the hole, insert a
small Allen wrench, punch or screwdriver into the hole
to feel when the notch is aligned with the hole.
12. Slowly rotate the snorkel tube clockwise while
counting the number of notches passing through the
hole opening as you rotate the tube. Rotate the
snorkel tube to the 3rd notch from the 'zero' backlash
position obtained in step 11.
13. Check the pinion shaft gear backlash again by feel. If
the pinion shaft gear lash appears to be too tight,
rotate the snorkel shaft clockwise to the next notch
(4th notch).
14. Once the backlash is set, apply Loctite
threads and install the locking screw to secure the
snorkel tube. Torque the locking screw to
specification.
TORQUE
Transmission Snorkel Tube Locking Screw:
10 ft-lbs (14 N·m)
Transmission Assembly
NOTICE
The snorkel shaft and pinion shaft must be installed
prior to transmission assembly. The snorkel shaft
cannot be installed after assembling the transmission.
15. Clean both transmission case halves thoroughly.
Inspect case half mating surfaces for damage.
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
© Copyright Polaris Industries Inc.
16. Assemble the reverse shaft assembly and input shaft
k
to reference assembly if previously disassembled (see
illustrations).
REF
l
1(
® 242 ™ to the
2)
2!
2@
2#
2$
2%
2^
TRANSMISSION
DESCRIPTION
Reverse Shaft
Low Gear
Engagement Dog
Reverse Sprocket
Silent Chain
Snap Ring
Bearing
High Gear
Input Shaft
7
7.29