Install The Network Loop Hardware - Nortel Meridian Mail Installation Quick Reference Manual

Installing the Meridian Mail to Meridian 1 interface

Install the network loop hardware

Install the network loop hardware
Determining the number of loops and loop cards needed
The number of loop cards needed in the switch depends on the number of
physical channels on your system, regardless of whether the channels are
configured for voice or multimedia use.
Loops and loop cards in an Enhanced MMP40 or MMP40 system
max # of physical
# of nodes channels
1
2
Installing the network loop card
See "Network loop card (QPC414)" on page 7-4.
Standard 1.0
# of loops
needed
24 1
48 2
Step Action
1 Select an available slot to install the network card in the
Meridian 1.
2 Note the slot number and its corresponding loop number for the
card. See Circuit Card Installation (NTP 553–3001–211).
3 Enter the loop number(s) in the Meridian Mail configuration.
Refer to the chapter on hardware administration in the Meridian
Mail System Administration Guide (NTP 555–7001–301).
4 Set the enable/disable switch on the faceplate to Dis.
5 Install the card.
Once installed, both LEDs on the card will light.
Modular Option EC Installation Quick Reference Guide
# of loop cards
needed
1
1
7-3
November 1999