Enabling The Aml - Nortel Meridian Mail Installation Quick Reference Manual

Configuring the Meridian 1 for Meridian Mail

Enabling the AML

Enabling the AML
Introduction
If you are using X11 Release 17 or earlier, follow the instructions in "Enabling
the ESDI port for AML (X11 Release 17 or earlier)" listed below.
If you are using X11 Release 18 or later, follow the instructions in "To activate
the AML link (X11 Release 18 or later)" on page 9-26.
To enable the ESDI port for AML (X11 Release 17 or earlier)
To enable the ESDI port for AML, follow these steps.
Standard 1.0
Step Action
1 Load Overlay 48.
2 Enter ENL ESDI n to enable ESDI port n .
3 Ensure that the AML link port is enabled, and the other port on
the ESDI port is configured (with the values IADR=1 and
RADR=3) and disabled.
When the LED on the ESDI card is lit it indicates that the card is
disabled. If the LED on the ESDI card is unlit then at least one
port is enabled.
4 Enter SLFT ESDI n to test ESDI port n .
If the system response is other than OK, see the SL–1
Maintenance Manual (NTP 553–3001–511) to analyze the
message.
5 Enter DIS ESDI n to disable ESDI port n .
6 Enter ACMS n to initiate the Auto Setup sequence and
establish the link.
7 Exit from Overlay 48.
Modular Option EC Installation Quick Reference Guide
9-25
November 1999