Configuring The Trunk Route Data Block (Nms Only) - Nortel Meridian Mail Installation Quick Reference Manual

9-16
Configuring the trunk route data block (NMS
only)
Note: Ensure that Digit Manipulation (DMI in Overlay 86) is not used to insert
ESN access codes at the sending switch. ESN access code insertion must be
done at the receiving switch. (at the INAC prompt in Overlay 16).
Overlay 16—Route data block parameters
Prompts Responses
REQ NEW or CHG
TYPE RDB
CUST
ROUTE
PNI
NCRD YES
TRO YES
INAC YES
<cr>
Standard 1.0 Modular Option EC Installation Quick Reference Guide
Configuring the Meridian 1 for Meridian Mail

Configuring the trunk route data block (NMS only)

Description
New or Change
Route data block
Meridian 1 customer number
Route number
Customer Private Network ID of the non–local target
Meridian 1
Network call redirection will provide the CLID
display information
Optimize trunk usage on this route
Insert ESN access code to incoming private network
call
Press carriage return to the end of the overlay. (The
prompt REQ comes up.)
November 1999