BOMBARDIER OUTLANDER 330 H.O. 2x4 Operator's Manual page 96

Disconnect the engine temperature
sensor connectors, then unscrew the
bleeding screw on the top of thermo-
stat housing.
1
V07C09Y
1. Bleeding screw
2. Engine temperature sensor
Drain the system completely and rein-
stall the coolant drain plug.
Pinch hose between radiator and ther-
mostat housing with a large hose
pincher (P/N 529 032 500).
94
V07C0AY
1. Hose pincher
2
Fill the radiator until the coolant comes
out by the thermostat housing hole. In-
stall the bleeding screw then remove
the hose pincher.
Complete the radiator filling.
Check the level in the coolant reservoir
and refill if necessary.
Run engine at idle with the radiator cap
off. Slowly add coolant if necessary.
At this point, wait until engine reaches
normal operating temperature. Depress
the throttle lever two or three times;
then add coolant if required.
Install radiator cap. Inspect all connec-
tions for leaks and check coolant level
in the reservoir.
Drive Belt
To check the drive belt, remove the
CVT cover on the left side of vehicle.
Measure and verify the drive belt. If
the drive belt width is equal or narrow-
er than 30 mm (1-3/16 in), or if flat
spots, cracks or other damages are vis-
ible, see an authorized Bombardier
ATV dealer to replace the drive belt.
Valve Adjustment
See an authorized Bombardier ATV
dealer for valves adjustment.
Insufficient clearance will cause loss
of power and possibly damage the
valves. Excessive clearance will cause
noise.
1