LUBRICATION AND MAINTENANCE CHART
I: Inspect, verify, clean, adjust, lubricate, replace if necessary
C: Clean
L: Lubricate
R: Replace
DRIVE TRAIN
Front/rear drive shaft boots and protectors ➃
Rear drive shaft joints
Rear propeller shaft joints (grease fittings)
Wheel bearings condition
Front/rear differential oil level, seals and vents
STEERING/CONTROL SYSTEMS
Handlebar fasteners
Throttle/housing/cable ➃
Choke condition ➃
Steering system ➂
Tie rod ends
Wheel nuts/studs
Wear/pressure of tires ➃
Front wheels alignment
SUSPENSION
Trailing arms ➃
Shock absorbers ➃
A-arms
BRAKE
Brake fluid front/rear ➃
Brake pads
Brake system (discs, hoses etc.)
BODY/FRAME
Engine compartment
Frame
Hitch/trailer ball condition (if installed)
Chassis fasteners
Seat fasteners
Vehicle cleaning and protection
➀
To be performed by an authorized Bombardier ATV dealer. The initial maintenance is
very important and must not be neglected.
➁ Every 100 hours, check coolant strength.
➂ More often under severe use such dusty area, sand, snow, wet or muddy conditions.
➃ Pre-ride inspection item.
➄ To be performed by an authorized Bombardier ATV dealer.
EVERY
I
I
I
I
L
I
I
I
I
I
I
I
I
I
I
I
I
I
EVERY RIDE
I
I
I
I
I
I
I
I
I
C
C
I
I
I
I
EVERY RIDE
C
CUSTOMER
DEALER
DEALER
CUSTOMER
R
DEALER
DEALER
CUSTOMER
CUSTOMER
DEALER
DEALER
CUSTOMER
CUSTOMER
DEALER
DEALER
DEALER
CUSTOMER
R ➄ CUSTOMER
CUSTOMER
CUSTOMER
CUSTOMER
DEALER
CUSTOMER
CUSTOMER
CUSTOMER
CUSTOMER
91