BOMBARDIER OUTLANDER 330 H.O. 2x4 Operator's Manual page 94

MAINTENANCE
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious injury
or death.
WARNING
Unless otherwise specified, en-
gine should not be running for all
maintenance procedures.
WARNING
Should removal of a locking device
(e.g. lock tabs, self-locking fasten-
ers, etc.) be required when under-
going disassembly/assembly, al-
ways replace with a new one.
The following covers the maintenance
items that can be performed by the cus-
tomer if desired. Other items found in
maintenance chart must be performed
by an authorized Bombardier ATV dealer.
NOTE: Among other things, this sec-
tion gives the procedures to replace
the liquids. Refer to LIQUIDS for pro-
cedures to check levels and refill.
Engine/Transmission
Oil Change and Oil Filter
Replacement
Oil and filter are to be replaced at the
same time. Oil change should be done
with a warm engine.
WARNING
The engine oil can be very hot. To
prevent burning yourself, do not
remove the engine drain plug or
the filter cover if the engine is hot.
Wait until engine oil is warm.
92
WARNING
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the oil drain plug area.
Place a drain pan under the oil drain
plug area.
Unscrew oil drain plug.
V07C03Y
1. Oil drain plug
Allow enough time for oil to flow out of
oil filter.
Remove the right engine cover.
Unscrew the oil filter cover.
1