BOMBARDIER OUTLANDER 330 H.O. 2x4 Operator's Manual page 104

V07I0JY
WARNING
Always wear eye protection and
gloves when you lubricate a cable.
NOTE: Place a rag around the throttle
cable adjuster to prevent the lubricant
from splashing.
Add lubricant until it runs out at carbu-
retor end of the throttle cable.
Reinstall and adjust the cable.
Throttle Lever Adjustment
Slide rubber protector back to expose
throttle cable adjuster.
Loosen lock nut then turn the adjuster
to obtain correct throttle lever free play.
NOTE: Measure throttle free play at the
tip of throttle lever.
Tighten lock nut and reinstall protector.
102
1
V07I010
1. Throttle lever
A. 3 to 6 mm (1/8 to 7/32 in)
With the transmission lever on PARK
position, start the engine. Check if the
throttle cable is adjusted correctly by
turning handlebar fully right then fully
left. If the engine RPM increases, re-
adjust the throttle lever free play.
Suspension
Lubrication
Lubricate front A-arms. Use synthetic
grease (P/N 293 550 033). There is
two grease fittings on each A-arm.
Inspection
Front Suspension
Inspect the McPherson struts for oil
leaks or other damages. Check tight-
ness of fasteners. See an authorized
Bombardier ATV dealer as necessary.
Rear Suspension
Inspect shock absorber for oil leaks and
fasteners for tightness. See an autho-
rized Bombardier ATV dealer as neces-
sary.
Trailing arms
Check trailing arms for distortion,
cracks or bending. See an authorized
Bombardier ATV dealer if any problem
is detected.
A