Config | Utility Page; Figure 4-5. Config | Utility Page - Comtech EF Data HPOD Installation And Operation Manual

4.5.5.3.2

Config | Utility Page

Use this page to configure HPOD operating parameters.
At any time, click [Refresh] to update this page and see the most recent data.
Date and Time
Enter the Date and/or the Time:
Field
Date
(MM/DD/YY)
Time
(HH:MM:SS)
Click [Change Date/Time] to save the settings.
Circuit ID
Enter a Circuit ID string of up to 48 characters. Click [Change CID] to save the string.
Current SC/13320 Active Firmware Image # (read-only)
This example identifies Image 1 as the Current Active Firmware Image.
Next Reboot Image – Use the drop-down list to select the Next Reboot Image as 1 or 2, and then
click [Submit] when done.
SC/13320 Board Firmware Version (read-only)
This read-only section identifies the current Boot, Bulk1, and Bulk2 firmware loads.
Ethernet-Based Remote Product Management

Figure 4-5. Config | Utility page

Format Minimum Value
Month 01
Day 01
Year 00
Hours 00
Minutes 00
Seconds 00
4–17
HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
Maximum Value
12
31
99
23
59
59
Revision 9
MN/HPOD.IOM