Admin | Snmp Page; Figure 4-3. Admin | Snmp Page - Comtech EF Data HPOD Installation And Operation Manual

4.5.5.2.2

Admin | SNMP Page

Sect. 4.3 SNMP INTERFACE
The Administrator must use this page to manage the HPOD SNMP (Simple Network
Management Protocol) settings.
At any time, click [Refresh] to update this page and see the most recent data.
SNMP

Simple Network Management – Use the drop-down list to set SNMP as Enabled or
Disabled.

Read / Write / Trap Community Strings – These defaults, set at the factory, may be
changed as needed:
Read Community String
Write Community String
Trap Community String

SNMP Contact / Name / Location – Enter this contact information as needed, in
alphanumeric format, up to a maximum of 20 characters.

Enabled Authentication Trap – Use the drop-down list to set the Authentication Trap as
Enabled or Disabled.

Trap IP 1 / Trap IP 2 – The Administrator can assign up to two SNMP Trap IP addresses in
the form 000.000.000.000.

Trap Version – Use the drop-down list to select the SNMP Trap as version SNMPv1 or
SNMPv2c.
Click [Submit SNMP] to save these changes or click [Reset] to revert to the previously assigned
SNMP settings.
Ethernet-Based Remote Product Management

Figure 4-3. Admin | SNMP page

Field Factory Default Name
public
private
comtech
HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
4–14
Revision 9
Number of
Format
Characters
0 to 20 alphanumeric
0 to 20 alphanumeric
0 to 20 alphabetic
MN/HPOD.IOM