Environmental Requirements; Connecting Power Supply; Electrostatic Protection - UNI-T UTS3000B/A Series User Manual

Spectrum analyzer
Table of Contents

Advertisement

Environmental Requirements

This instrument is suitable for the following environment:
Indoor use.
In operating: altitude lower to 3000 meter;in non-operating: altitude lower to 15000 meter.
Operating temperature 0℃ to﹢40℃; Storage temperature -20℃ to +70℃(unless otherwise
specified).
In operating, humidity temperature below to +35℃, ≤90% relative humidity;
In non-operating, humidity temperature +35℃ to +40℃, ≤60% relative humidity.
There are ventilation opening on the rear panel and side panel of the instrument. So please keep the air
flowing through the vents of the instrument housing. To prevent excessive dust from blocking the vents,
please clean the instrument housing regularly. The housing is not waterproof, please disconnect the
power supply first and then wipe the housing with a dry cloth or a slightly moistened soft cloth.

Connecting Power Supply

The specification of AC power supply that can input
Voltage Range
100-240VAC
100-120VAC
Please use the attached power lead to connect to the power port.
Connecting to service cable
This instrument is a Class I safety product. The supplied power lead has good performance in terms of
case ground. This spectrum analyzer is equipped with a three-prong power cable that meets
international safety standards. It provides good case grounding performance for the specification of your
country or region.
Please install AC power cable as follows:
• ensure the power cable is in a good condition.
• leave enough space for connecting the power cord.
• Plug the attached three-prong power cable into a well-grounded power socket.

Electrostatic Protection

Electrostatic discharge may cause damage to component. Components can be damaged invisibly by
electrostatic discharge during transportation, storage and use.
The following measure can reduce the damage of electrostatic discharge,
• Testing in antistatic area as far as possible;
• Before connecting the power cable to the instrument, inner and outer conductors of the instrument
should be briefly grounded to discharge static electricity;
Frequency
50/60Hz
400Hz
18 / 78

Advertisement

Table of Contents
loading

Table of Contents