Led Wiring - Honeywell Silent Knight IntelliKnight 5820XL Installation And Operation Manual

4.8.3

LED Wiring

There are four 12-pin connectors on the 5880 board for connecting LEDs. Each LED gets its
power from Pin 11. Internal resistors are sized so that there is approximately 10 mA of current
for each LED, no series resistors are required. LED outputs can be mapped to output circuits.
See Section 6 for programming details.
Wire the LEDs as shown in Figure 4-22.
On connector P1, Pin 12 is an open collector output for controlling a PZT. If used, the 5880
PZT will match the PZT pattern of the on-board (or 5860) annunciator.
Note: The circuit connected to "Open Collector Output" (last pin on P1) must be current limited so that no more
than 100 mA of current is allowed to flow into the open collector transistor.
Programmable Open Collector Output
Not mappable.
Matches PZT pattern
on on-board
annunciator
151209
5880 LED Outputs
1
P1
2
3
4
5
6
7
8
9
10
LED Power
11
P2
12
13
14
15
16
17
18
19
20
LED Power
no connection
Connectors P3 and P4 wired same as P2.
Figure 4-22 5880 Board Layout
firealarmresources.com
Control Panel Installation
Cathode
LEDs
Anode
Cathode
LEDs
Anode
4-23