Table of Contents
Advertisement
IntelliKnight 5820XL Installation Manual
Maintenance alert region
Point status eliminates calibrated smoke test requirements for NFPA 72
•
"JumpStart" feature for easy programming
•
Non-volatile event history stores 1000 events
•
A choice of output patterns available for notification outputs, including ANSI 3.41
temporal signal
•
Built-in synchronization appliance support for AMSECO, Faraday, Gentex
®
Sensor
, and Wheelock
1.2
About this Manual
This manual is intended to be a complete reference for all installation and operation tasks for
the 5820XL. Please let us know if the manual does not meet your needs in any way. We value
your feedback!
1.2.1
Terms Used in this Manual
The following terminology is used with the IntelliKnight 5820XL system:
Term
SLC
Module
Input Point
Input Zone
Output Point
(or Output Circuit)
Group (or "Output Group")
Output (or "Cadence") Pattern
Mapping
1-2
®
.
Table 1-1
Signaling line circuit
The term module is used for all hardware devices except for SLC
addressable devices and notification appliances. This includes the 5820XL
panel itself and the built-in 5897 power supply. It also refers to any
(optional) 5815XL SLC expansion modules.
An addressable sensing device, such as a smoke or heat detector or a contact
monitor device.
A protected area made up of input points.
A notification point or circuit for notification appliances. Relay circuits and
auxiliary power circuits are also considered output points.
A group of output points. Operating characteristics are common to all
output points in the group.
The pattern that the output will use, for example, Constant, March Code,
ANSI 3.41. Applies to zones and special system events. See Section 7.6.3.2
for additional information.
Mapping is the process of specifying which outputs are activated when
certain events occur in the system. Section 6.2 explains mapping in detail.
firealarmresources.com
Description
®
, System
151209
Advertisement
Table of Contents
Troubleshooting
