Hoover H7W4 48MBC-S Manual page 8

2-Installation
Note: Keep in safe place
Keep all parts of the transport protection in a safe place for later use. Whenever the
appliance is to be moved at first reinstall the protection parts.
2.4 Moving the appliance
If the machine is to be moved to a distant location, replace the transportation bolts
removed before installation to prevent damage: The assembly takes place in reverse
order.
2-4
2.6 Aligning the appliance
Fix the water drain hose properly to the piping. The hose has to reach at one point a height
between 80 and 100 cm above the appliance bottom line! if possible keep always drain
hose fixed to the clip at the appliance back.
WARNING!
Use only the supplied hose set for the connection.

Never reuse old hose sets!

Only connect to cold water supply.

Before connection, check whether the water is clean and clear.

8
2.5 Aligning the appliance
Adjust all feet (Fig.2-4) to achieve a complete level
position. This will minimize vibrations and thus noise
during use. It will also reduce wear and tear. We
recommend to use a spirit level for adjustment.
Floor should be as stable and flat as possible.
1. Loose the locknut (1) by using a wrench.
2. Adjust the high turning the foot (2).
3. Tighten locknut (1) against the housing.
EN