2-Installation - Hoover H7W4 48MBC-S Manual

EN

2-Installation

2.1 Preparation
 Make sure there is no transport damage.

Make sure all transport bolts are removed.
 Handle the appliance always with at least two persons because it is heavy.

Take the appliance out of the packaging.
Remove all packaging material including protecting film on cabinet, polystyrene

base, keep them out of children reach. While opening the package, water drops may
be seen on plastic bag and porthole. This normal phenomenon results from water
tests in the factory.
Note: Packaging disposal
Keep all packaging materials out of children's reach and dispose them in an
environmentally friendly manner.
2.2 OPTIONAL: Install noise reduction pads
1. When opening the shrink package, you will find four
noise reduction pads. These are used for reducing
noise (Fig. 2-1).
2. Lay the washing machine down to its side, porthole
pointing upwards, bottom side towards operator.
3. Take out the noise reduction pads and remove the
double-sided adhesive protective film; paste arou-
nd the bottom; the noise reduction pads under the
washing machine cabinet as shown in Figure 3 (two
longer pads in position 1 and 3, two shorter pads in
position 2 and 4). Finally set the machine upright
again.
2.3 Dismantle the transportation bolts
The transport protection on the rear side is designed
for clamping anti-vibration components inside the a-
ppliance during transportation to prevent inner dam-
age. All elements (T1,T2,T3 and T4, Fig 2-2) must be
removed before use.
1. Remove all 4 bolts (T1 - T4) (Fig. 2-3).
2. Fill the 5 holes with blanking plugs.
Please note: for 8kg models, please
fill the 4 holes with blanking plugs.
2-Installation
1 2
3
2-1
Packing boll(1234)
Remove the four
packing bolls
2-2
2-3
Hole wall(12345) l
Plug the five hole walls
7