Hoover H7W4 48MBC-S Manual page 37

Hide thumbs Also See for H7W4 48MBC-S:
Table of Contents

Advertisement

EN
Problem
Excessive foam
floats drum and/or
detergent drawer.
Automatic
adjustment of
washing time.
Spinning fails.
Unsatisfactory
washing result.
Washing powder
residues are on the
laundry.
Laundry has grey
patches.
Note: Foam formation
If too much foam is inspected during spin cycle, motor stops and drain pump will be
activated for 90 seconds. If that elimination of foam fails up to 3 times, programme ends
without spinning.
Should the error messages reappear even after the taken measures, switch off the
appliance, disconnect the power supply and contact the customer service.
11.4 In case of power failure
The current programme and its setting will be saved.
When power supply is restored operation will be
resumed.
If a power failure cuts an operating wash programme
door opening is mechanically blocked. To get out any
laundry water level should not be seen in the glassy
porthole of the door. - Danger of burns! Water level
has to be lowered as described in "Pump filter". Not till
then pull lever (A) beneath service flap (Fig. 11-1) until
door is unlocked by a gentle click. Afterwards refix all
parts.
When the washing machine in a safe state (under the water level below the window along
a certain distance, barrel temperature below 55
unlock the doors of the machine operation.
Cause
• Detergent is not appropriate.
• Excessive use of detergent.
• Washing programme duration will be
adjusted.
• Unbalance of laundry.
• Degree of pollution does not agree
with selected programme
• Detergent quantity was not sufficie-
nt.
• Maximum load has been exceeded.
• Laundry was unevenly distributed in
the drum.
• Insoluble particles of detergent can
remain as white spots on the laundry.
• Caused by fats such as oils, creams
or ointments.
11-Troubleshooting
Solution
• Check detergent recommendat-
ions.
• Reduce amount of detergent.
• This is normal and doesn't affect
functionality.
• Check machine load and laundry
and run a spinning programme
again.
• Select an other programme.
• Choose the detergent acc. to the
degree of pollution and according
to manufacture
• Reduce loading.
• Loose the laundry.
• Perform extra rinse.
• Try to brush the points from the
dry laundry.
• Choose an other detergent.
• Pretreat the laundry with a special
cleaner.
, the inner barrel did not turn), may
°C
11-1
37

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

H7w449ambc-s

Table of Contents