Hoover H7W4 48MBC-S Manual page 29

EN
8.10 Start wash programme
Touch "Start/Pause" button (Fig. 8-7) to start.
Appliance operates according to present settings.
Changes are only possible by cancelling the programme.
8.11 Interrupt / cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED above the button
is flashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Touch "Start/Pause" button to interrupt the running programme.
2. Turn the knob to the programme DRAIN & SPIN and select"NO SPIN" to drain the water.
3. After closing the programm to restart the appliance, select a new programme and
start it.
4. After closing the programm to restart the appliance, select a new programme and
start it.
8.12 After washing
Note: Door lock
 For safety reasons the door is locked partially during the washing cycle. It is only
possible to open the door at the end of the programme or after the programme was
cancelled correctly (see description above).
 In case of high water level, high water temperature and during spinning it is not
possible to open the door; Lock is displayed.
1. At programme cycle END is displayed.
2. The appliance switches off automatically.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4. Turn off the water supply.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not
used.
Note: Standby-mode / energy-saving mode
The switched on appliance will go into standby-mode if it will not be activated within 2
minutes before starting the programme or at the end of programme, except REMOTE
CONTROL.The display switches off.This saves energy.To interrupt the standby mode
turn the knob to any other programme except "OFF".
8.13 Activate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. In the standby mode after power on, long press the button "OPTION"for more than 5S
to turn off the sound. The interface will display "SOUND OFF". Press and hold this key
again for more than 5S, and the interface will "SOUND ON".
8-Daily use
8-7
29