Custom Types; Universal Setup - Lexmark C770 User Manual

Menu selection Purpose
Card Stock Loading Properly handles card stock
whether the job is a duplexed or
single-sided job.
Custom <x> Loading Properly handles preprinted
custom paper whether the job is
a duplexed or single-sided job.

Custom Types

This menu selection is used to define a name for each custom paper type. You can assign names using a utility such as
MarkVision or from the operator panel.
Menu selection Purpose
Custom Type [x] Specifies the type of paper
associated with each Custom Type
available in the Paper Type menu.

Universal Setup

This menu selection is used to specify the height and width of the Universal Paper Size. By specifying the height and width
for Universal Paper Size, the printer will use the Universal setting exactly like other paper sizes, including support for duplex
and n-up.
Menu selection Purpose
Units of Measure Determines the unit of measure
used to enter the Universal
Height and Width.
Portrait Width Sets the portrait width of the
universal media.
Note: If the value set exceeds
the maximum width, the printer
will use the maximum value
allowed in inches or millimeters.
Portrait Height Sets the portrait height of the
universal media.
Note: If the value set exceeds
the maximum height, the printer
will use the maximum value
allowed in inches or millimeters.
Feed Direction Specifies the feed direction of
the Universal Paper Size.
Using printer menus
Values
Duplex
Off*
Duplex
Off*
Values
Paper*
Card Stock
Transparency
Glossy
Labels
Vinyl Labels
Envelope
Values
Inches (US)
Millimeters (non-US)
3 inches to 48 inches in
0.01 inch increments
76 mm to 1219 mm in 1
mm increments
3 inches to 48 inches in
0.01 inch increments
76 mm to 1219 in 1mm
increments
Short Edge*
Long Edge
14
Shown if Card Stock is supported in the
specified input source.
Shown if the custom type is supported in
the specified input source.
The custom type media must be
supported in the input source you
designate in order to assign a user-
defined name.
Once the name is assigned, the
name (truncated to 24 characters)
will be displayed instead of Custom
Type x.
Inches is the US default; Millimeters is
the international default.
Shows either inches or mm from Units
of Measure setting; 8.5 inches is the
US default, and 216 mm is the
international default.
Shows either inches or mm from the
Units of Measure setting; 14 inches is
the US default, and 356 mm is the
international default.
Long Edge is only shown if the
longest edge is shorter than the
Maximum Physical Width of the
printer.