Lexmark C770 User Manual page 53

Message
Remove paper from standard output
bin
Remove paper from bin <x>
Remove paper from all bins
Remove paper from
<linked set bin name>
Replace ITU
Replace Fuser
Resetting Active Bin
Resetting Fuser Count
Resetting the Printer
Restore Held Jobs
Restoring Factory Defaults
Restoring held job(s) x/y
Serial <x>
Setup Required
check <area name>
Some held jobs were not restored
Standard Bin Full
Submitting selection
Tray <x> Empty
Tray <x> Low
Tray <x> Missing
Unlocking Printer
USB
USB <x>
Understanding printer messages
Action
Remove the stack of paper from the standard output bin.
Remove the paper from the specified output bin.
Remove the paper from all output bins.
The printer automatically senses media removal and resumes printing.
If removing the media does not clear the message, press
• Image transfer unit is at end of life.
• Replace the image transfer unit.
Replace the fuser. If the fuser is not replaced when the warning is
cleared, the printer will post the warning again.
Wait for the message to clear.
Wait for the message to clear.
Wait for the message to clear.
• Press to restore all Print and Hold jobs on the hard disk.
• Select Do not restore to delete Print and Hold jobs.
Wait for the message to clear.
Note: When factory default settings are restored:
• All downloaded resources (fonts, macros, symbol sets) in the printer
memory are deleted.
• All menu settings return to the factory default setting except:
– The Display Language setting in the Setup Menu
– All settings in the Parallel Menu, Serial Menu, Network Menu,
Infrared Menu, LocalTalk Menu, USB Menu, and Fax Menu.
• Wait for the message to clear.
• Select Quit restoring to delete unrestored Print and Hold jobs.
Note: x represents the number of the job being restored, and y
represents the total number of jobs to be restored.
A serial interface is the active communication link.
Packing material was detected in one or more areas. Remove any
remaining packing material.
• Press to clear the message and continue printing.
The printer frees memory by deleting the oldest held job and
continues deleting held jobs until there is enough printer memory to
process the job.
• Cancel the current job.
Remove the stack of paper from the bin to clear the message.
Wait for the message to clear.
Load paper in the tray to clear the message.
Add paper to the tray to clear the message.
Insert the tray into the printer.
PIN entry is successful. Wait for the message to clear.
The printer is processing data through the specified USB port.
53
.