Lexmark C770 User Manual page 33

Menu selection Purpose
PCL Emulation Changes the point size for
Settings scalable typographic fonts.
Specifies the font pitch for
scalable monospaced fonts.
Determines how text and
graphics are oriented on the
page.
Determines the number of lines
that print on each page.
Sets the width of the logical
page for A4 size paper.
Specifies whether the printer
automatically performs a
carriage return after a line feed
control command.
Specifies whether the printer
automatically performs a line
feed after a carriage return
control command.
Using printer menus
Values
Point Size:
1.00–1008.00 (12*)
Pitch:
0.08–100.00 (10*)
Orientation:
Portrait*
Landscape
Lines per Page:
1–255
60* (US)
64* (non-US)
A4 Width:
198 mm*
203 mm
Auto CR after LF:
Off*
On
Auto LF after CR:
Off*
On
33
Point size refers to the height of the
characters in the font. One point
equals approximately 1/72 of an
inch. You can select point sizes from
1 to 1008 in increments of 0.25
points.
Note: Point Size is only displayed
for typographic fonts.
Pitch refers to the number of fixed-
space characters in a horizontal
inch of type. You can select a pitch
from 0.08 to 100 characters per inch
(cpi) in increments of 0.01 cpi. For
nonscalable monospaced fonts, the
pitch is displayed but cannot be
changed.
Note: Pitch is only displayed for
fixed, or monospaced, fonts.
Portrait prints text and graphics
parallel to the short edge of the
paper.
Landscape prints text and graphics
parallel to the long edge of the
paper.
The printer sets the amount of
space between each line (vertical
line spacing) based on the Lines per
Page, Paper Size, and Orientation
menu items. Select the correct
Paper Size and Orientation before
changing Lines per Page.
Note: The 203 mm setting makes
the logical page wide enough to
print eighty 10-pitch characters.
Off—Printer does not perform a
carriage return after a line feed
control command.
On—Printer performs a carriage
return after a line feed control
command.
Off—Printer does not perform a line
feed after a carriage return control
command.
On—Printer performs a line feed
after a carriage return control
command.