Lexmark C770 User Manual page 52

Message
No jobs found
Retry?
No jobs to cancel
No recognized file types
Not ready
Overflow Bin Full
Parallel <x>
Port disabled Remove USB drive
Power Saver
Printer locked, enter PIN to unlock
Printing
Printing from USB drive
DO NOT REMOVE
Printer busy
Continue
Quit
Programming System Code
DO NOT POWER OFF
Programming Flash
DO NOT POWER OFF
Programming Disk
DO NOT POWER OFF
Reading USB drive DO NOT REMOVE
Ready
Reattach <device>
Remote Management Active
DO NOT POWER OFF
Understanding printer messages
Action
Note: The four-digit personal identification number (PIN) you entered is
not associated with any confidential print job.
• Select Retry to enter another PIN.
• Select Cancel to exit the Enter PIN screen.
Wait for the message to clear.
Wait for the message to clear.
Note: The only supported file type is PDF.
The printer is offline.
Press to return to normal operation.
• The mailbox's designated overflow bin is full.
• Remove the stack of paper from the bin to clear the message.
A parallel interface is the active communication link.
Wait for the message to clear.
• Send a job to print.
• Press to warm the printer to normal operating temperature and
display the Ready message.
The operator panel has been locked.
Enter the correct PIN number.
Wait for the message to clear.
Warning: Do not turn the printer off or remove the USB drive while this
message is displayed.
Wait for the message to clear.
Press to read the information from the USB drive.
Select Quit to cancel the information retrieval process.
Warning: Do not turn the printer off while this message is displayed.
Wait for the message to clear and the printer to reset.
Warning: Do not turn the printer off while this message is displayed.
Wait for the message to clear.
Warning: Do not turn the printer off while this message is displayed.
Wait for the message to clear.
Wait for the message to clear.
Send a job to print.
The specified device is either not fully connected to the printer or is
experiencing a hardware failure.
• Reestablish communication by removing the specified device and
reattaching it to the printer.
• Press to clear the message and continue printing without using
the device.
• In the case of a hardware failure, turn the printer off and back on. If
the error recurs, turn the printer off, remove the specified device, and
call for service.
The printer settings are being configured, and the printer was taken
offline to ensure it is not currently printing and processing jobs.
Wait for the message to clear.
52