Lexmark C770 User Manual page 54

Message
USB device unsupported
USB drive removed
USB hub unsupported
View supplies
Waiting
Waste Toner Life Warning
1565 Emul Error Load Emul Option
30 <color> toner cartridge missing
31 Defective <color> cartridge
32 Replace unsupported <color>
cartridge
34 Incorrect media
34 Short Paper
35 Insufficient memory to support
Resource Save feature
36 Printer service required
37 Insufficient memory to collate
job
37 Insufficient memory for Flash
Memory Defragment operation
37 Insufficient memory, some held
jobs were deleted
Understanding printer messages
Action
Remove the USB device to clear the message.
• Wait for the message to clear.
• Insert the USB drive.
Remove the USB device to clear the message.
Displays the current level of all printer supplies.
The printer has received a page of data to print, but is waiting for an End
of Job command, a Form Feed command, or additional data.
• Press to print the contents of the buffer.
• Cancel the current job.
• Waste toner bottle is nearly full.
• Replace the waste toner bottle.
The printer automatically clears the message in 30 seconds, and then
disables the download emulator on the firmware card.
Download the correct download emulator version from the Lexmark Web
site.
Install the specified toner cartridge, and close the front cover.
Replace the specified toner cartridge, and close the front cover.
Remove the toner cartridge, and install a supported one.
• Load the appropriate media in the selected source.
• Press to clear the message and print the job using a different
paper source.
• Press to clear the message and continue printing.
The printer does not automatically reprint the page that prompted the
message.
• Check tray length and width guides to ensure paper is properly fitted
in the tray.
• Make sure the print job is requesting the correct size of paper.
• Adjust the Paper Size setting for the size paper you are using.
If MP Feeder Size is set to Universal, make sure the paper is large
enough for the formatted data.
• Cancel the current job.
• Press to disable Resource Save and continue printing.
• To enable Resource Save after you get this message:
– Make sure the link buffers are set to Auto, then exit the menus to
activate the link buffer changes.
– When Ready is displayed, enable Resource Save.
• Install additional memory.
Press to clear the message and continue printing.
• Press to print the portion of the job already stored and begin
collating the rest of the job.
• Cancel the current job.
• Press to stop the defragment operation and continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
The printer was unable to restore some or all of the confidential or held
jobs on the hard disk.
Press to clear the message.
54