Lexmark C770 User Manual page 55

Message
38 Memory Full
39 Page is too complex to print
40 [color] invalid refill, change
cartridge
50 PPDS font error
51 Defective flash detected
52 Not enough free space in flash
memory for resources
53 Unformatted flash detected
54 Serial option <x> error
54 Network <x> software error
54 Standard network software error
55 Unsupported option in slot <x>
56 Parallel port <x> disabled
56 Serial port <x> disabled
56 Standard USB port disabled
Understanding printer messages
Action
• Press to clear the message and continue printing.
The job may not print correctly.
• Cancel the current job.
• Install additional printer memory.
• Press to clear the message and continue printing.
The job may not print correctly.
• Cancel the current job.
• Install additional printer memory.
Replace the specified toner cartridge, and close the front cover.
• Press to clear the message and continue printing.
The job may not print correctly.
• Cancel the current job.
Press to clear the message and continue printing.
You must install different flash memory before you can download any
resources to flash.
• Press to clear the message and continue printing.
Downloaded fonts and macros not previously stored in flash memory
are deleted.
• Delete fonts, macros, and other data stored on the flash memory.
• Install a larger capacity flash memory card.
Press to clear the message and continue printing.
You must format the flash memory before you can store any resources
on it. If the error message remains, the flash memory may be
defective and require replacing.
• Make sure the serial link is set up correctly, and you are using the
appropriate cable.
• Make sure the serial interface parameters (protocol, baud, parity, and
data bits) are set correctly on the printer and host computer.
• Press to clear the message and continue printing.
The job may not print correctly.
• Turn the printer off and then on to reset the printer.
• Press to clear the message and continue printing.
The job may not print correctly.
• Program new firmware for the network interface.
• Reset the printer.
1 Turn the printer off.
2 Remove the unsupported option.
3 Turn the printer on.
• Press to clear the message.
The printer discards any data received through the parallel port.
• Make sure the Parallel Buffer menu item is not set to Disabled.
• Press to clear the message.
The printer discards any data received through the serial port.
• Make sure the Serial Buffer menu item is not set to Disabled.
• Press to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
55