Table of Contents
Advertisement
• 4 GB of DDR4 programmable logic (PL) memory
• 2 GB of DDR4 processor system (PS) memory
• MSP432-based satellite controller (SC) for card monitoring and telemetry
• PCIe Gen 3 x16 or Gen 4 x8 bifurcated host interface
• Low profile (HHHL) single slot (111.15 mm x 167.65 mm) form factor with a 60W power
envelope
• DMB II maintenance and debug port for card maintenance and developer support functions
Note: The proprietary DMB II interface requires a Xilinx ADK dongle.
Software Overview
The T2 card has a factory image installed that together with the provided host software
installation supports the following functions:
• PCIe Gen3 x16 interface
• User flash image update
• SC firmware update
• DDR4 PL BERT performance and diagnostics test
• DDR4 PS BERT performance and diagnostics test
• PCIe performance and diagnostics test
• In-band telemetry
Zynq UltraScale+ RFSoC Specification
The Zynq UltraScale+ RFSoC device on the T2 card is a XCZU48DR-2FSVG1517E. A comparison
of the features of this device relative to other devices in the same family is shown in the
following figure. Refer to the Zynq
details.
UG1496 (v1.0) June 15, 2022
T2 Telco Accelerator Card User Guide
®
UltraScale+™ RFSoC
Product Selection Guide
Chapter 1: Introduction
for further
www.xilinx.com
Send Feedback
5
Advertisement
Table of Contents
