Table of Contents
Advertisement
This chapter details how to install your graphics accelerator in your system as well as
where to download associated software and drivers.
2.1 Installation Overview
Once you have determined that your system meets the minimum requirements,
perform the following tasks to install your new graphics accelerator. Detailed
installation instructions are provided in the following sections.
1.
2.
3.
4.
5.
6.
7.
2.2 Installing a PCI Express Graphics Card
Please read all installation instructions completely before you begin.
If your computer has on-board graphics, you may need to disable it through the BIOS
configuration. For more information, see your motherboard documentation.
Note: Always handle a graphics card with care when adding or removing it from
your system.
•
•
•
1. Turn off your computer, monitor(s), and other peripheral devices.
© 2012 Advanced Micro Devices Inc.
Hardware and Software Installation
If you are replacing an existing graphics accelerator, uninstall the old graphics
driver and software.
Note: If you are using a motherboard containing an on-board graphics solution
and do not intend to use it as part of a multiple monitor display, disable it.
Turn off and disconnect your computer system.
If needed, remove any old graphics accelerator(s).
Install the new graphic accelerator.
Reassemble and connect your computer system and display(s).
Start the computer system and install the AMD FirePro™ drivers and
configuration software.
Restart the computer system.
Never twist or bend your card.
Avoid interference from the card's fan housing with mechanical hinges or clips
inside your system's chassis.
Make sure that the PCIe® card slot-locking mechanism on the motherboard is
unlocked or open before inserting or removing a card. Please consult your
motherboard manual for instructions, if necessary.
Chapter 2
AMD FirePro™ W9000 Graphics Accelerator
Advertisement
Table of Contents
