Table of Contents
Advertisement
USER program duration customisation (optional, only if installed)
Steam extraction time setting (optional if installed)
Service setting (for After-Sales Service only)
7.3 Starting the peristaltic pumps – rapid filling of detergent and rinse aid
delivery circuit.
Perform after the parameter modification procedure explained in the previous point
With the dishwasher powered up and the tank full,
press the on/off
---- appears on the display, release the button and
press it again quickly within 0.5 seconds.
The peristaltic pumps continue to operate until the
same button is pressed again. The rinse aid and
detergent symbol lights flash alternately as long as
the pumps are on; bear in mind that the rinse aid
peristaltic pump fills the circuit in about 7 minutes,
while for the detergent it only takes 2 minutes. So
draw only rinse aid from the jerry cans (1 for the rinse
aid and the other for the detergent) for the first 5
minutes and then also take in detergent for the last 2.
On some models, the message
may appear during the setup procedure. To reset the message, open the
dishwasher door and close it again. If the message persists, contact the after-sales
service.
P2..... followed by two dashes (e.g. P2--). Keep pressing the
button for a few seconds; when --
USER. is the only program which can be customised.
Scroll through the setup parameters to display USER.P1,
P button until USER appears followed by the duration
(e.g. USER. 03.10).
Steam extraction system operating time display and
See information on Smegtech
(PCB self-diagnostics on dishwasher closure)
"door"
23
setting.
Advertisement
Table of Contents
