Table of Contents
Advertisement
13 TROUBLESHOOTING
In case the pump is not working properly, follow the steps
below:
Empty the dishwasher out using a container and disconnect
the power.
Remove screw A, release tab B and lift it upwards.
Make sure that the covered drain pump impeller can rotate
freely, and that there are no dirt residues, limestone, or pieces
of glass. Do not use tools, screwdrivers, scissors, etc.
PROBLEM
THE INDICATOR LIGHT L1
DOES NOT LIGHT UP
THE WASHING PROGRAM
DOES NOT START
POOR WASHING RESULTS
POSSIBLE CAUSE
line voltage failure
The dishwasher filling is not
over yet.
CLOSE stays on display
Clogged or crusted spray
arms holes.
Clogged filter
Insufficient or improper
detergent or rinse aid.
Failing or insufficient use of
detergent or rinse aid: the
detergent or rinse aid cannot
be withdrawn from the
dedicated containers.
Badly positioned dishes /
glasses.
Low washing temperature
37
B
POSSIBLE SOLUTION
Verify electricity connection.
Wait for FILL to disappear off the
display
If CLOSE stays even with the hood
closed, contact the After-Sales
Service.
Dismount and clean the spray arms
(10.2 Periodical checks)
Read "cleaning the filters during the
day"
Verify detergent type and quantity.
Worn or broken internal tube for
detergent or rinse aid of the
peristaltic pump, to be replaced by
the After-Sales Service.
This ordinary maintenance service is
recommended at least once a year
for the correct functioning of the
dosers.
Place dishes / glasses correctly.
Verify the temperature displayed, if it
is inferior than 50°C contact
customer Support.
A
Advertisement
Table of Contents
