Smeg UD515D Translation Of The Original Instructions page 22

"Clean water" cycle
Thermostop
If the thermostop device is set "off" the rinsing °t are no longer monitored and the user is
responsible for ensuring that the minimum correct °t are maintained for the tank and boiler. It is
particularly important to check the intake water temperature.
Also refer to the insufficient washing/drying /foam in tank point of the "troubleshooting" section :
restore °t Stop ON and/or connect the appliance to a hot water supply.
High speed (FST) or economy (ECO) filling (FILL)
Cycles performed counter
When this option is activated, the appliance pumps out
all the water from the tank and then refills it with clean
water at every wash cycle. How long this operation takes
depends on the washing water temperature.
On: enabled – OFF: disabled.
N.B.: prolonged use of this option leads to higher
detergent and rinse aid consumption.
Set to "on"" = minimum washing and rinsing
temperature set for the tank and boiler regardless of
the inlet water temperature; the nominal duration of the
cycle could be a few seconds longer.
Set to "off" = the minimum rinsing temperature could
be a few degrees lower than the one set if hot inlet water
Set to "boi" = minimum rinsing temperature set for the
Fast start (FST): starts the dishwasher in less than the
standard time; leads to higher water consumption for the
Eco start (ECO): starts the dishwasher in standard time,
with no added water consumption.
On: enabled – OFF: disabled.
Shows the count of the total cycles performed by the
dishwasher since installation.
This parameter cannot be modified or reset unless the
software is reprogrammed.
22
is not used.
boiler.
first cycle start.