Processor Configuration And Setpoints - Kodak Ektascan 2180 User Manual

Processor Configuration and Setpoints

Setup information consists of the film processor configuration and process setpoints.
Setup information that was preset at the factory is listed below.
Setup information is stored in battery backed-up RAM (Random Access Memory).
Therefore, you do not need to program new values every time that you turn on the
Processor. Even if power to the Processor is interrupted or the Processor is turned
off, you do not need to program the Processor.
If you wish, you may change the setup information by using the function keys on the
display panel. See Section 13, "Setting Up the Processor," for more information. The
new setup information will be retained in memory when power is interrupted or turned
off.
The Processor configuration and setpoints are initially set up as follows:
Replenishment Mode
Display Units
Developer Temperature
Fixer Temperature (minimum)
Automatic Developer Replenishment
(35 x 43 cm sheet)
Automatic Fixer Replenishment
(35 x 43 cm sheet)
Flooded Developer Replenishment
(35 x 43 cm sheet)
Flooded Fixer Replenishment
(35 x 43 cm sheet)
Dryer Temperature
5B9615
Processor Overview
Automatic
°F
37.8°C
(100°F)
37.8°C
(100°F)
60 mL
85 mL
65 mL
65 mL
48.9°C
(120°F)
11–7