Table of Contents
Advertisement
3
The following screen will be displayed.
Click on the item to check the information or change
its settings.
The printer's status is displayed here.
[Ready / Busy / Status message]
More details on Status messages and how to correct
problems can be found under "Status messages, LCD
messages and LED behaviors".
» »
Refer to "Status messages, LCD messages and LED
behaviors" on page 65.
Changes the display language.
After selecting the language, click on [Accept].
Input "admin" into the "Password" field, then click on [Login]
then, create the Password as you like.
» »
Refer to "Login Password" on page 56.
Device Status
You can check the status of the unit, such as remaining ink level.
Device Configuration
•
General Settings
You can change the following items.
• Default Paper Size/Type
If you change this setting, the default Paper Size/Type in Copy
Menu setting are also changed.
• Sleep mode time
You can change the time required before unit enters Sleep mode
from [1 min/10 min/20 min/30 min/40 min/50 min/60 min/70
min/80 min/90 min/100 min/110 min/120 min].
•
Print Reports
You can print out the configuration report.
•
Factory Reset
You can restore the default settings to the unit.
Note(s)
❏
• The unit will automatically restart after reset to factory settings.
(The Web Interface will be disconnected.)
English
Network
If necessary, you can confirm or set the state of the Network. If you
are not familiar with Network management, use the default settings.
Note(s)
❏
• Be careful if you want to assign the IP address manually. If the
IP address you entered is not correct, you will not be able to
connect to the unit. When you cannot connect to the unit after a
configuration change, please reset the unit.
» »
Refer to "Restore Factory Default" on page 52.
• When the connection of the unit is changed, the Web interface
will be disconnected. If necessary, reconnect the Web interface.
•
Enable Wi-Fi
You can turn On / Off the Wireless function.
Note(s)
❏
• Even if the Wireless function is set to Off, when you connect by
Easy Simple Print, the Wireless function will be valid.
• When you have connected the unit to the Access Point/Router, if
you set to disable Wi-Fi, you will not be able to operate from the
Web Interface. If you connect to Wi-Fi again, select the "Enable"
from the "Enable Wi-Fi" of unit menu.
» »
Refer to "Enable Wi-Fi" on page 48.
54
Continued on next page.
Advertisement
Table of Contents
