Hints On Hardware And Software Versions - Roland R4000 Manual

B0059001 / Rev. 2.3
11.3

Hints on Hardware and Software versions

Index of changes
Communication module
KM V1.15 Introduction: Cancelling on entering password is possible
04.04.2006
Introduction: Printing the system settings without change mode is possible
Introduction: Filter „SAF"
"SAF" stands for "Signal Activity Filter", representing the filter function more correctly.
Introduction: Bus error message (Fieldbus): "Bus transfer disturbed"
Introduction: Y stretching limited 1...10
Only in combination with PM V12 or later
KM V1.16 Introduction: Automatic restart after changing of settings. (from serial number 400059).
28.07.2006
(if restart required)
KM V1.17 Introduction: Round specimen: Visualization of weld seam width in graphics.
12.04.2007
Introduction: Flat specimen: Visualization of both limits at filter „bipolar".
Introduction: Transmission of signal-noise ratio in dB (up to 34 dB) and visualization in log files
Change: StartUp fault; „24V voltage fault" redressed.
KM V1.18 Change: Signal-noise ratio extended to 40dB resp. >40dB
13.07.2007 Only in combination with PM V14 or later
KM V1.19
Change: SnlogFile extended to 14 days.
30.07.2007
Change: Storing fault messages of PM in SNLogFile.
KM V1.20
Introduction: New language: Portuguese, new MUI file:„SND40.exe.0416.mui".
27.10.2007
Introduction: New SND40Store software
KM V1.21
Introduction: New language: Spanish, new MUI file: „SND40.exe.0c0a.mui".
09.01.2008
KM V2.04 Introduction: Extension French + Optimizer + 99 Programs.
19.09.2008
KM V2.05 Optimizer locked 31 Prog.
25.02.2009
KM V2.06 Optimizer free 31 Prog. Error: Memory problems existing!!
09.12.2009
KM V2.07
Memory problem fixed
07.01.2010
KM V2.08 On old mainboards also showing message „please restart"
03.07.2012
KM V1.21 Introduction: New language: Spanish
09.01.2008
new MUI-file: „SND40.exe.0c0a.mui".
KM V10-1.00 For SND40 units with NETDCU 10 (Defective version on round objects)
25.04.2010
KM V10-1.01 For SND40 units with NETDCU 10 (Defective version on round objects)
10.10.2010
KM V10-1.03
For SND40 units with NETDCU 10 (Defective version on round objects fixed)
17.01.2012
KM V10-1.04 For SND40 units with NETDCU 10 Added on param. „detection quality": extra + ultra
09.07.2012
KM V10-1.05 For SND40 units with NETDCU 10 + NETDCU A5: New language Russian
01.01.2016
KM V10-1.06 For SND40 units with NETDCU 10 + NETDCU A5
01.01.2016
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Manual
Technical records
163