Mitsubishi MELSEC-Q Series User Manual page 464

9 TROUBLE SHOOTING
Error
Error name
code
Device write disable
0908h (tag component test)
error
Write disable setting
0909h (tag component test)
error
09A0h
System error
0A00h
0A01h Access log open error
0A02h Access log read error
Access log registration
0A03h
error
0A04h Access log close error
Access log
0A05h
initialization error
0A06h Illegal access log error
Out-of-range setting
0A07h
file access error
New setting file
0A08h
creation error
Setting file update
0A09h
error
0A0Ah Setting file seek error
0A0Bh Setting file close error
9 - 39
Error definition
Execution of the tag component
test was attempted when Device
write disable request (YA) is on.
Execution of the tag component
test when "Disable" was set to
"Data write" in the tag setting.
Failed to open the access log.
Failed to read the access log.
Failed to register the access log.
Failed to close the access log.
Failed to initialize the access log.
The access log is corrupted.
Access was made to outside the
setting file range.
Failed to create a new setting file.
Failed to update the setting file.
Failed to seek the setting file.
Failed to close the setting file.
(From the previous page)
Corrective action
• Turn off Device write disable
request (YA) and execute again.
• Set "Enable" to "Data write" in
the tag setting and execute
again. (Refer to Section 6.3.3)
• System error ( 1)
• Check File access status (X2).
• Execute File access stop cancel
(Y3). (Refer to Section 3.6.2.)
• Check File access status (X2).
• Execute File access stop cancel
(Y3). (Refer to Section 3.6.2.)
• Check File access status (X2).
• Execute File access stop cancel
(Y3). (Refer to Section 3.6.2.)
• Check File access status (X2).
• Execute File access stop cancel
(Y3). (Refer to Section 3.6.2.)
• Check File access status (X2).
• Execute File access stop cancel
(Y3). (Refer to Section 3.6.2.)
• Check File access status (X2).
• Execute File access stop cancel
(Y3). (Refer to Section 3.6.2.)
• Check File access status (X2).
• Execute File access stop cancel
(Y3). (Refer to Section 3.6.2.)
• Check File access status (X2).
• Execute File access stop cancel
(Y3). (Refer to Section 3.6.2.)
• Check File access status (X2).
• Execute File access stop cancel
(Y3). (Refer to Section 3.6.2.)
• Check File access status (X2).
• Execute File access stop cancel
(Y3). (Refer to Section 3.6.2.)
• Check File access status (X2).
• Execute File access stop cancel
(Y3). (Refer to Section 3.6.2.)
(Continued on the next page)
MELSEC-Q
Error type
Display
Display
Stop
Display
Display
Display
Display
Display
Display
Display
Display
Display
Display
Display
Display
9 - 39