Mitsubishi MELSEC-Q Series User Manual page 263
Web server module
Hide thumbs
Also See for MELSEC-Q Series:
- Programming manual (1296 pages) ,
- User manual (814 pages) ,
- Reference manual (532 pages)
Table of Contents
Advertisement
6 FUNCTIONS
6 - 61
(e)
Restoration value
1)
Set the restoration value to make the event disappear.
2)
The restoration value can be set when the condition is >=, >, < or <=.
3)
In the following case, the event is restored.
Condition
Component = Trigger value
Component <> Trigger value
Component >= Trigger value
Component > Trigger value
Component < Trigger value
Component <= Trigger value
(f)
Send an e-mail when an event occurs.
1)
Set whether e-mail will be sent upon event occurrence or not.
2)
Refer to Section 6.6.6 for e-mail transmission by the event monitor
function.
(g)
Disconnect from the network after sending mail.
Disable this setting when it is not desired to disconnect the network after
sending e-mail at event occurrence.
This setting is available when the Web server module is not continuously
connected to the network.
Refer to Section 5.4 for the procedures for connecting to and disconnecting
from the network for non-continuous connection.
(h)
E-mail main text
1)
Enter the main text of e-mail.
(0 to 256 characters)
2)
Refer to Appendix 4 (5) for the characters applicable to the e-mail
main text.
(i)
Attached file
1)
Select the file attached to e-mail.
(None, Tag data, Logging Data)
2)
When attaching tag data, select the tag data set in the tag setting.
(Refer to Section 6.3.3 for the tag setting.)
3) When attaching logging data, select the logging data set in the logging
setting. (Refer to Section 6.4.4 for the logging setting.)
(j)
Send to 1 to 16
1)
Select the destination of e-mail.
2)
Select the e-mail address set in the "E-mail address (TO:) setting" of
the E-mail setting. (Refer to Section 6.6.3 for the E-mail setting.)
3)
In the selection field for Send to, the setting No. and e-mail address of
the "E-mail address (TO:) setting" are displayed.
POINT
After changing the settings, make sure to click on the "Save" button.
The settings are updated when the "Update" button on the Setting update screen is
clicked, the programmable controller is powered off and then on, or the CPU
module is reset.
MELSEC-Q
Restoration
Component <> Trigger value
Component = Trigger value
Component < Restoration value
Component <= Restoration value
Component >= Restoration value
Component > Restoration value
6 - 61
Advertisement
Table of Contents
