Omron FZ5 Series Hardware Setup Manual page 71

Component Names and Functions
(A)
(B)
(C)
(D)
(E)
(F)
Connector name
(A) SD memory card
installation con-
nector
(B) Ethernet connec-
tor
(C) USB connector
(D) RS-232C connec-
tor
(E) DVI-I connector
(F) I/O(Parallel) con-
nector (control
lines, data lines)
(G) EtherCAT
address setup
volume
(H) EtherCAT com-
munication con-
nector (IN)
(I) EtherCAT com-
munication con-
nector (OUT)
(J) Encoder connec-
tor
(K) Camera connec-
tor
Vision System FZ5 series Hardware Setup Manual (Z423)
(G)
(H)
(I)
(J)
(K)
(L)
Install the SD memory card. Do not plug or unplug the SD memory card during mea-
surement operation. Otherwise measurement time may be affected or data may be
destroyed.
Connect an Ethernet device.
FH-1050/FH-3050
Ethernet port,
EtherNet/IP port, and
PROFINET port are
sharing use.
Connect a USB device. Do not plug or unplug it during measurement.
Measurement time might be affected otherwise.
Connect an external device such as a PLC.
Connect a monitor.
Connect the controller to external devices such as a sync sensor and PLC.
Used to set a station address (00 to 99) as an EtherCAT communication device.
Connect the opposed EtherCAT device.
Connect the opposed EtherCAT device.
Connect an encoder.
Connect cameras.
3 Configuration
Description
FH-1050-10/-20, FH-3050-10/-20
FH-2000/5000 series
Upper port :
Ethernet port
Lower port :
Ethernet port,
EtherNet/IP port, and
PROFINET port are
sharing use.
3
3 - 9