Omron FZ5 Series Hardware Setup Manual page 260

6 I/O Interface
FH-VPX-FZL
 Connection Structure
PLC, terminal blocks or
other products
Connector
No.
CN1
CN2
CN3
CN4
*1. COM terminal polarity of NPN/PNP
COMIN
COMOUT
6 - 36
Connecting the FZ-VP
* After the connection, lock it securely.
FZ-VP / FZ-VPX
Connection Destination
Connect to the parallel port CN1 of the FH Sensor
Controller.
Connect to the parallel port CN2 of the FH Sensor
Controller.
Connect to the Parallel I/O cable FZ-VP.
Connect to 24 V power source depending on the
PN/PNP polarity as below table.
NPN PNP
+V -V
-V +V
FH controller
and the FH-VPX-
CN3
CN1
FH-VPX-FZL
CN4
CN2
Even if you connect the revers CN1 and
CN2, Sensor Controller does not per-
form.
It is immune to breakdown.
Connect to the Parallel I/O cable
FZ-VP.
• When power source and DI0 are
non-isolated and no problem:
Possible to connect the power source
same as FH series.
• When you want to isolate the power
source and DI0:
Disposable to use the power source of
FH series.
Connect the other power source to
CN4.
Recommendation: S8VS series 24
VDC.
Vision System FZ5 series Hardware Setup Manual (Z423)
Parallel connector
(CN1/CN2)
Power supply used
in the FH controller:
Power supply S8VS
series (24 VDC)
Special Notes
---