Omron FZ5 Series Hardware Setup Manual page 153

Component Names and Functions
●Front view
(1) LED indicator lamp
●Connection terminal
(8) RS-232C
(9) USB (TypeB)
(1) LED indicator lamp
(2) VESA mounting hole Mounting hole for VESA 75 mm × 75 mm.
VESA mounting hole Mounting hole for VESA 100 mm × 100 mm.
(3)
(4) USB retaining
bracket
(5) Power supply termi-
nal
(6) Monitor connector
(analog RGB)
(7) OSD Menu button
(8) RS-232C
(9) USB (TypeB)
(10) Touch pen
(11) Touch pen holder
(12) Mounting Brackets
For operation at launch OSD, refer to the Model FH-MT12 INSTRUCTION SHEET.
Vision System FZ5 series Hardware Setup Manual (Z423)
(7) OSD Menu button
(6) Monitor connector
(analog RGB)
Name
Lit up green when power is ON.
Lit up orange when video signal is no input.
Unlit when power is OFF.
Retaining bracket for USB cable.
Connect a 24 VDC power supply.
Connect a monitor cable for analog RGB.
The button to activate the OSD menu.
Connect a serial communication port for touch panel communication.
Connect a USB port (Type B) for touch panel communication.
Use for operation of touch panel.
Put touch pen in it when not using.
Paste it on the monitor by double-sided tape.
Use them to mount the panel.
●Rear view
(2) VESA mounting hole pitch 75 mm (M4)
(3) VESA mounting hole pitch 100 mm (M4)
(4) USB retaining bracket
(11) Touch pen holder
(10) Touch pen
Description
3 Configuration
(5) Power supply terminal
(12) Mounting Brackets
3 - 91
3