Omron FZ5 Series Hardware Setup Manual page 165

Precautions for Correct Use
Installation and Storage Sites
• Install and store the product in a location that meets the following conditions:
• No rapid changes in temperature (place where dew does not form)
• No presence of corrosive or flammable gases
• Place free of dust, salts and iron particles
• Place free of vibration and shock
• Place out of direct sunlight
• Place where it will not come into contact with water, oils or chemicals
• Place where is near no high-voltage instrument or power machine
• Do not install the product immediately above significant heat sources, such as heaters,
transformers, or large-capacity resistors.
• Do not install the product in a cabinet containing high-voltage equipment.
• Do not install the Sensor Controller within 200 mm of power cables.
Handling of Sensor Controller
• Touching Signal Lines
When touching a terminal part or a signal wire in a connector, take anti-static measures using
a wrist strap or another device to prevent damage from static electricity.
• Handling a USB flash drive/SD memory card
Before removing a USB flash drive or SD memory card, make sure that data is not being
read or written to them.
Maintenance
• Lightly wipe off dirt with a soft cloth.
• Do not use thinners or benzine.
• Clean the lens with a lens-cleaning cloth or air brush.
• Dirt on the image element must be removed using an air brush.
Vision System FZ5 series Hardware Setup Manual (Z423)
4 Handling and Installation Environment
4
4 - 3