Enter User Codes - NAPCO GEMINI GEM-P1632 Programming Instructions Manual

WI1148B 10/06
Acc #
( _ _ _ _ )
(Direct Entry)
RecFm t
( )
(Direct Entry)
User01
______
(Direct Entry)
OPT__
(Direct Entry)
ACC __
(Direct Entry)
L
NAPCO Security Systems
Central Station Receiver 1 Account Number
Enter an account number of up to four digits. Use number buttons
NOTE: Press the
G 0
Press the NEXT/YES button to proceed.
NOTE: Central Station Receiver 2 and 3 Account Numbers can only be entered in Direct Address
Programming. See CS Reporting Options.
Central Station Receiver 1 Format
From the table below, enter the central station's receiver format. Use number buttons
NOTE: Press the
G 0
through
1 G 4
to proceed.
NOTE: Central Station Receiver 2 and 3 Formats can only be entered in Direct Address Programming. See
CS Receiver Options.
DATA ENTRY CS RECEIVER 1 FORMAT
•(blank) Ademco Slow, Silent Knight Slow
2 Radionics Fast
3 Silent Knight Fast
4 Radionics, DCI, Franklin Slow
Enter User Codes (Press the (
For default program, enter up to 32 User Codes, with Area 1 and Area 2 Options.
Press once to set the cursor to the User Code. Use the number buttons
R
to enter a code from 3 to 6 digits. Enter up to 6 digits (4 digits is recommended) in the first six boxes
from left to right for each user code. Valid entries are: 0-9. NOTE: Press
for a blank space (•). No blank spaces in between; leave blank (•) any trailing boxes. If
G0
"Enable Global Ambush Code" (Address 0720) is enabled and "Global Ambush Code" (Address 1054)
is not left blank(•), do not program the first two digits of ANY User Code the same as the "Global
Ambush Code". Note: If the programmed code was less than 6 digits, press
the Area 1 Options Level (OPT). Refer to the table on the next page for the available area options.
Note: Duplicate User Codes are not allowed; therefore a duplicate Code entered in the LCD Window will erase
U
when is pressed.
buttons for a zero and press
buttons for a zero and press
for letters B–E, respectively. Press
DATA ENTRY
) button to set cursor.)
R
X
through
1 9
for a blank space (•). Press
0
1
for a blank space (•). Press
0
U
to save. Press the NEXT/YES button
CS RECEIVER 1 FORMAT
5 Universal High Speed
B SIA
C Ademco Point ID
E Pager
1
for a zero and press
0
R
GEM-P1632 Programming Instructions
Page 9
for digits 1–9.
U
to save.
through .
9
G
through
9
to set the cursor to