Conventions Used In This Manual - NAPCO GEMINI GEM-P1632 Programming Instructions Manual

WI1148B 10/06
The displays shown on the previous pages will appear after a brief delay.
Use to toggle the cursor between the 4-digit address field and the data entry locations.
R
Enter the address directly using the number buttons.
The contents of the address will be read automatically, along with the feature name and programming information.
The cursor will advance to the data field. Enter the required data directly using the number buttons.
U
Press to save the contents of each address.
EXIT DIRECT ADDRESS PROGRAM MODE: When done, press

CONVENTIONS USED IN THIS MANUAL

The Keypad Programming Worksheets in the back are provided as an address-programming reference to help the
installer modify his custom default program or to make
minor field alterations to an existing panel program. It is
recommended that the panel be uploaded to NAPCO's
PCD-Windows software
programming and that the PCD-Windows error-check
feature be utilized to reduce the possibility of
programming omissions or conflicts.
Note: Most of the addresses shown comprise two data
entry locations, left and right digits. Program the left
digits on the left data-display segment, and the right
digit on the right segment. For those addresses having
only one programmable nibble, program the right
segment only; the left segment should display a blank
(•).
3
Keep the Keypad Programming Worksheets on file for
future reference.
General Programming Steps
1. Contact the central station to ascertain receiver
format, data format, event codes, subscriber
numbers and telephone number(s).
2. Select the desired features by circling
respective "address"
Programming Options and Worksheets for guidance
in selecting the "data" (1,2,4,8) to be entered into
those boxes.
3. Program the data entered in the boxes on the
worksheets into the respective addresses.
display will show the entry numerically, but will
display "0" for the number 10, and letters "B", "C",
"D", "E", and "F" for the numbers 11 through 15,
respectively. To program a 10, press
. To program 11 through 15, press
0
through
1 G 5
NOTE: See the Direct Address Programming Example
on the previous page.
L
NAPCO Security Systems
following any keypad
the
boxes. Refer to the
The
G
G
, respectively.
to exit and resume normal keypad operation.
C
DATA ENTRY SELECTIONS
(BINARY VALUE CIRCLED)
8 4 2 1
8 4 2
8 4 1
8 4
8 2 1
8 2
8 1
8
4 2 1
4 2
4 1
4
2 1
2
1
Table 1 (above). Determining data entry for a location
(each "nibble"). Numbers in parentheses indicate data for
selected zones or features.
Worksheets that follow).
X
GEM-P1632 Programming Instructions
Page 23
ENTRY PRESS
TOTAL N
blank 0
1 1
2
2
3
3
4
4
5
5
6
6
7
7
8 8
9 9
G 0
10
G 1
11
G 2
12
G 3
13
G 4
14
15 G 5
(See Programming
KEYPAD
DISPLAYS
•
1
2
3
4
5
6
7
8
9
0
B
C
D
E
F